So I thank you sys for all of your patience and explanations there. Im sorry for sounding like such an idiot! I did get the “TTL” to control the laser, the module switches were set incorrectly. Feel like I might regret opening that Pandora’s box. I contemplated doing the dual firmware 2.0 firmware from: but I don’t want to hook up the end stops and I seem to recall something not working right if the end stops aren’t there. I mean life goes on but I hate feeling like Im missing something. What is the difference between the Multiphase (Eularian) Model and the Discrete Phase ModelI want to simulate an laser abalation process. I can call M42 P45 S255 and presto it works… M3/M5 never make any changes for that pin though… I can make it function on the 12v fan output but that removes my relay to turn on/off fans/vacuums etc. I have checked and checked and checked and M3 M5 they are still set for pin 45. Russia’s largest modelling school is in Novosibirsk. The visitors still take a few photos and recommend she go on a diet. ![]() When I upload the new sketch there is a Led just above the fan2 port that comes on when I issue an M3 but it only goes off if I reset the board. At 93 centimetres, her hips are too wide. ![]() I have made the single edit that I can see needs to be changed. Ive tried to enable the M3 and M5 commands.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |